Crown XLC2500 Power Amplifier for Cinema/Install, 500W @ 4 Ohms

Crown XLC2500 Power Amplifier for Cinema/Install, 500W @ 4 Ohms Features

- Minimal front panel control; block connectors and controls on back of amplifiers
- High performance lightweight DriveCore based amplifier for audiophile quality and extremely high reliability
- Configurable input operation for stereo and parallel and bridge modes
- Configurable output operation for stereo and bridge modes
- Compatible with CXM2000 for monitor, fault detection and crossover functions
- Compatible with Crown Monitor System DSi-8M for monitor function
- Power for 2-ohm, 4-ohm and 8-ohm outputs, supporting stereo and bridge outputs
- Support parallel connection of cinema surround speaker
- Indicators provide accurate diagnostics: Power, Signal, Clip and Fault
- Volume control on rear panel of amplifiers
- High performance, light weight
- DriveCore based amplifier - weighs less than 14lbs (6 kgs)

Crown XLC2500 Power Amplifier for Cinema/Install, 500W @ 4 Ohms Specifications

- AC Line Voltage and Frequency Configurations Available: (± 10%) 100VAC 50/60 Hz, 110VAC 60 Hz, 220 and 230~240VAC 50 Hz
- Voltage Gain: 35
- Sensitivity: 1.4V (for full rated power at 4 Ω)
- Signal to Noise Ratio (ref. rated power, 8 Ω, 1 kHz): > 103 dB
- THD: <0.5%
- Damping Factor (8 Ω, 10 Hz to 400 Hz): >200
- Intermodulation Distortion (from full rated output to -30 dB): <0.3%
- Frequency Response (at 1W, 20 Hz - 20 kHz): 0 dB
- Crosstalk:
  - >85 dB (below rated 8 Ω power, at 1 kHz)
  - >55 dB (below rated 8 Ω power, at 20 kHz)
- Input Impedance (nominal):
  - Balanced: 20 kΩ
  - Unbalanced: 10 kΩ
- Load Impedance:
  - Stereo: 2~8 Ω per channel in Stereo
  - Bridged: 4~8 Ω in Bridge
- Dimensions: 19 x 3.5 x 8 inches (48.3 x 8.9 x 20.6 cm)
- Weight: 8.3 lbs (3.75 kg)
- IEC Power Connector: 15A

Further Product Information Below

Crown XLC Series Manual (PDF)

Crown XLC Series Data Sheet (PDF)